Amazon Price: $7.99 $7.99 (as of July 20, 2018 8:48 am –
12V inverter, if the actual power under 240W of the electrical equipment, this item can be used; 24V inverter, if the actual power under 480W of the electrical equipment, this item can also used.
The 500W or 1000W power of the inverter is nominal power.
The fuse of this product is 15A (Max is 20A) , the current inside the car must below the fuse current of this product.
If the power and current of electrical equipment is larger. This product will get to hot. And the spring inside will get to hot. If the current is more larger, then the fuse will burnout to have protective effects.
So Please correct to use this product. This product is high quality, please be assured to use it.
Default 15A fuse, and come with extra free 20A fuse to spare.
Wire Size: The wire diameter is 0.11811 inch. One Red wire, One Black wire. Two wire diameter is 0.23622 inch.
The size of the hole in the ring terminal: 0.25 inch / 1/4".
1 X 1M/3.3FT wire cigarette lighter plug
Don’t waste money/time on others
After purchasing a less expensive same type of product on Amazon and having it fail in minutes, I bought this product. Although a few dollars more, I highly recommend spending the extra money. I use it now primarily to illuminate LED bulbs which I install into housings prior to permanently installing into automotive vehicles. I know this is not “heavy lifting”, but my original purchase couldn’t even deal with that. Judging by the quality of the material, and just the feel of this product in the hand, I would have no worries about using it for powering heavier 12v powered equipment. Just as a comparison, the first one purchased came with one 2A fuse installed and 2 1/2″ leads. More than enough for my application, but it failed as I said in minutes. This came with a 15A (widely available) fuse installed, an additional spare 20A fuse, and 38″ 1.5mm (16AWG) leads. A robust tool IMO.
Works on my 400W inverter
I used this to replace the 12V male connector that came with my 400W inverter that I crushed with the truck door. Works great, came with 15A and 20A fuses.
Great for Replacing a Broken Plug
I ordered this item to replace a broken plug on my old 12v compressor/inflator….. which I have done. With a bit of wire splicing and soldering, it turned out to be exactly what I needed. The stranded copper wire was exactly the same size as the wire on my old compressor, contributing to an easy repair. I have tested the compressor with the new plug, and it works like new.
Works perfect. I cut the ends off me used Bullet …
Works perfect. I cut the ends off me used Bullet connectors. I ordered two of these and both came with an extra fuse. Makes I easy to add power. I used mine for a CB radio in each car.
Long cord is a plus. Can plug into car outlet in 2nd row & charge our cell phone is the front console.
Have an old UHF Marine radio that used to be in our boat. Bought this to hook up, along with wall adapter, so that I could either use in car or plug into the wall in my garage. Long cord is a plus! Can plug into car outlet in 2nd row & charge our cell phone is the front console. Link to
Excellent product and well made.
Well made. I bought this to replace the power cord on the Inverter that came with my Desk for the passenger seat in my car. The old one was not nearly as well made as this one. Excellent fit and it does not wiggle loose in my VW cigarette lighter socket. Highly recommend!
High quality connector. Using it to power a 400w inverter in my truck although you have to be careful that you don’t pull more than 180-200 watts from a cigarette lighter connector. It has a very nice tight connection in the lighter socket which is important because loose connections mean excess heat/blown fuses/melted plastic.
Yup, surprised here. The quality was a lot …
Yup, surprised here. The quality was a lot more than I was expecting based on the price. Would purchase again if needed. The plastic was not exactly cheaper end.
Perfect for my application
Perfect for my application. I cut the ends and created my own harness for a custom install. The quality is good and even includes an extra in line fuse. It does not feel cheap in your hand and is built sturdy with screws holding the assembly together.
Totally met and exceeded my expectations.
Totally met and exceeded my expectations. Arrived on time and the quality was solid. Used it to repair the power leads on my 12V tire pump. I was dealing with a crappy plastic plug that had a crack in it. I enjoy using it again for my bikes and cars. This new MotoCity replacement is worth every penny for quality that should last.